LED resistor calculator
I connect to and let it glow .
Why a resistor?
An LED runs on a low voltage, around 2 to 3 volts. A battery or adapter gives more. Without a resistor the LED draws too much current and breaks within seconds. The resistor holds the current back, so the LED lights just right.
How to connect it
- 1Find the long leg of the LED. That is the plus.
- 2Put the resistor between the plus of your supply and that long leg.
- 3Connect the short leg to the minus of your supply.
Good to know
- Every LED gets its own resistor. Ten LEDs means ten resistors.
- A slightly higher resistor is always fine: the LED just glows a little softer. A lower one is not.
- LEDs in different colours? Work it out per colour. Red and yellow need a different resistor than blue and white.
- The voltage of your LED is on its product page. In doubt, pick the higher resistor.
Check it yourself
Supply minus LED, divided by the current in amps.
(5.0 V − 2.1 V)÷0.020 A=145 Ω
Voltage per colour
2.0 V
red
2.0 V
orange
2.1 V
yellow
3.0 V
green
3.2 V
blue
3.2 V
white
Typical values at 20 mA. Does your LED list another voltage? That one counts.
